Fine Wool Combs - With Holder - Smooth Points - Stainless Steel Tines

Description

Smooth points, stainless steel tines, and crafted from cherry wood with a Danish oil finish. These combs are your perfect go-to. Available in Fine and Extra fine, there’s an option for all fiber types.
Included is: A set of Fine wool combs, Comb Holder, and 2 Clamps.
What makes our combs special?
·
Smooth points won’t catch on your fiber.
The points on these combs are silky smooth with a long taper to allow them to slide through your fiber without catching.
·
Sharp, but not too sharp.
We apply a micro tip bevel on the points to keep them from being too sharp but allowing them to penetrate your fiber smoothly. Needle sharp points are unnecessary and dangerous to use.
·
Won’t rust.
Our tines are made from sturdy stainless steel, if you need to spritz your fiber with a little water to keep the static down, you won’t have to worry about rusting the points.
·
Comfortable to hold and use.
Ergonomic, smooth, one-piece handle feels natural in your hand.
·
Beautiful.
Made from cherry hardwood and finished with hand rubbed Danish Oil Finish.
·
Made in the USA
·
Lightweight.
The tines are 3.25 inch by 4 inch perfectly balancing weight and working area.
·
Available in two sizes
: (This listing is for a Fine set of Combs)
Fine:
Perfect for medium fibers. The tines are set approx. ¼” apart.
Extra Fine:
Perfect for finer fibers. The tines spaced approx. 3/16” apart.
·
Ships free to the lower 48 States.
·
With special thanks to Susan McFarland
(Author of Combs Combs Combs) for her expert advice, feedback, and input throughout the designing process.
·
The included wool comb pad can be clamped or screwed to a table to hold one comb stationary while you work the fiber with the free comb.
·
Made from Cherry Wood and finished with Danish Oil Finish.
·
Handy Knob adds extra stability to the comb during use.
·
A comb holder makes easy work of pulling fiber off the comb using a diz, or by hand.
The table clamps can grip to a surface 2 ½” or thinner. Table or counter MUST have a square edge to clamp from the front. If the surface you are clamping to has a beveled edge you will need to clamp it to the corner for a proper hold.